S4wiki:Community Portal

What is the Community Portal?

The Community Portal is the central place to find out what's happening on S4Wiki. Learn what articles need to be written, what questions need to be answered, and what articles still need a lot of work.

If you wish to edit this page, please see Wikipedia's Community Portal for an example of how a wiki community portal should look.

If you are looking for other external Audi S4 related sites, check out the external links page!

To do lists

Questions that need answering MAF Bosch signal characterization What voltage indicates "zero" flow? What voltage indicates negative flow? Does the ECU use it? Is MAP used in characteristic curve when ECU detects broken/unplugged MAF? Lemmiwinks High EGT (>980°C) and IAT (>120°F) corrections.. is there a flag for each, or is the correction progressive? does it affect both fueling and timing? does it affect req boost? does it affect load calculations? Generations There is some confusion with cars near the 09/00 build mark Some are 2001, some are 2001.5 (no verification of this rumor) Some 2001.5 came with h-boxes and do not appear to have F-hoses (doubtful, probably incorrect report) Articles that need work Long term fuel trim/Short term fuel trim These articles were directly stolen from this BMW OBD-II article. They need to be checked for accuracy wrt. the S4 and ME7.1

Articles that need content Open loop/closed loop What determines which is used when? What inputs are used in each to determine fueling closed loop -> base maps + IAT?/EGT? correction + adapt channels + ltfts? (derived from stfts) + stfts? stfts derived from narrow band open loop -> base maps + IAT?/EGT correction + adapt channels + trims? + load (derived from maf) What inputs are used in each to determine boost What inputs are used in each to determine timing base maps + IAT/EGT correction + retard (derived from correction factor) correction factor derived from kvs What inputs are used in each to determine throttle plate angle desired load (based on throttle position during partial throttle or target idle torque if throttle postion is zero) vs calculated load (based on MAF) add in cruise control, traction control, engine protection (e.g. throttle cut) O2 sensor Knock control Relationship between KVs and timing correction factor Direct? Filtered/corrected somehow? Are logged KV's corrected? Characteristic curve When is it consulted? During both open/closed loop? Is MAP used? What if ECU detects broken/unplugged MAP? Manifold air pressure Synchronous path/Asynchronous path Synchronous path outputs: VVT, ignition timing, injector pulse width Asychronous path outputs: requested boost, throttle plate angle Variable valve timing F-hose Why does it exist? Delete howto Master boost controller Parallel vs series vs alone Tuning Relation to throttle cut and TCD Throttle cut defender aka MAP clamp