Motronic abbreviations: Difference between revisions

From S4wiki
Jump to navigation Jump to search
No edit summary
No edit summary
Line 21: Line 21:
;KLAF: Outflow characteristic for adjusting the standard flow measured at an above-critical rate of flow to below-critical rates of flow
;KLAF: Outflow characteristic for adjusting the standard flow measured at an above-critical rate of flow to below-critical rates of flow
;KUMSRL: Parameter for determining the relative cylinder charge from the air mass flow, the engine speed, and the piston-swept volume
;KUMSRL: Parameter for determining the relative cylinder charge from the air mass flow, the engine speed, and the piston-swept volume
;lde - LadeDruckError: plsol-plist (boost deviation - feedback input to the LDRPID)
;lde - LadeDruckError: pssol-ps or plsol-plist (boost deviation - feedback input to the LDRPID)
;LDR - LadeDruckRegelung: Boost pressure regulation
;LDR - LadeDruckRegelung: Boost pressure regulation
;ldtv - LadeDruckTastverhältnis: Wastegate duty cycle
;ldtv - LadeDruckTastverhältnis: Wastegate duty cycle

Revision as of 23:55, 5 August 2008

In general, all lowercase acronyms are calculated values; maps and other acronyms are typically all caps.

ASR - AntiSlipRegelung
Anti slip control
B_ldob - LadeDruck OverBoost
1 - overboost enable (dynamic driving, use KFVPDKSD), 0 - overboost disable (steady driving, use KFVPDKSE)
B_ldobsp
Post overboost lock-out bit (force overboost enable - ignore steady driving resumption)
DIA
Diagnosis
DK - DrosselKlappen
Throttle plate
DKW - DrossellKlappenWinkel
Throttle plate angle
DLR - DeltaLambdaRegelung
Delta lambda regulation
DMD - Delta Moment Dashpotende
?
DMD
Diagnose Misfire Detection
DV-E - ?
Wastegate
evtmod - EinspritzVentil Temperature (mod=Model?)
Estimated fuel injector temperature
FGR - FahrGeschwindigkeitsRegler
Cruise control
fkmsdk
Multiplicative correction quantity for determining pvdk (pressure upstream of throttle plate) from measured ambient air pressure (pvdkds)
fpvdk
pvdk/1013 hPa (correction factor for adjusting the air mass flow at standard pressure upstream from throttle valve to instantaneous conditions)
ftbr
???
ftvdk
Intake air temperature compensation factor for converting the standard air mass flow to an air mass flow at an instantaneous temperature
furl?
fupsrl - Faktor Umrechnungs von ps->rl
rlsol/pssol (conversion factor for converting the intake manifold pressure to a relative charge in % per hPa)
KLAF
Outflow characteristic for adjusting the standard flow measured at an above-critical rate of flow to below-critical rates of flow
KUMSRL
Parameter for determining the relative cylinder charge from the air mass flow, the engine speed, and the piston-swept volume
lde - LadeDruckError
pssol-ps or plsol-plist (boost deviation - feedback input to the LDRPID)
LDR - LadeDruckRegelung
Boost pressure regulation
ldtv - LadeDruckTastverhältnis
Wastegate duty cycle
Md
misfire detection?
nmot
Engine speed (RPM)
NWS - KnockWelleSteuerung
Cam shaft control
RLFS - Relativ LuftFüllung Steuerung?
Relative air charge control?
rlroh
Air mass flowing into the intake manifold, uncorrected relative charge of a cylinder
rlsol
Requested load (which is capped by engine load corrected specified)
rk - Relativ Kraftstoffmasse
Relative fuel mass
prg?
pirg
Correction of the intake manifold pressure by exhaust gas recirculation, partial pressure of internal exaust gas recirculation
plg - Pressure Ladedruck Grund
reference pressure for vpssplg ratio
plist
Actual boost pressure upstream of throttle plate
plsol
pssol/vpsspls (requested boost pressure upstream of throttle plate). When vpsspls is lower (e.g. during "dynamic driving"), plsol will be higher (overboost). When vpsspls is higher (e.g. during "steady driving"), plsol will be lower (no overboost).
ps
Actual intake manifold pressure
pssol
rlsol/fupsrl (requested intake manifold pressure downstream of throttle plate)
pspvdk
ps/pvdk (pressure ratio of the pressure drop over the throttle plate)
pvdk
pvdkds * fkmsdk (pressure upstream of the throttle plate)
pvdkds
Ambient pressure measured by a pressure sensor
pu - Umgebungsdruck
Ambient pressure
Tans - Temperatur ansaugluft
Intake air temperature
Tmot - Temperatur motor
Motor (coolant) temperature
TV - Tastverhältnis
Duty cycle
te - Einspritzzeit/dauerung effektiv
Effective injector on time
ti - Einspritzzeit/dauerung
Injector on time (actual)
Verhältnis
ratio
vpssplg - Grundladedruckverhältnis
pssol/plg? (pressure ratio between requested intake manifold downstream of throttle plate and reference pressure?)
vpsspls
pssol/plsol (pressure ratio across throttle plate)
vpsspu
pssol/pu (ratio of requested intake air pressure downstream of throttle plate to ambient air pressure)